Deploying AutoCAD 2013 via Group Policy

I initially created a group policy as I’ve always done. Set package installation paths, point to the MSIs. Seems like that didn’t work too well. After a gpupdate /force, the workstation will look like it’s installing the software but when you log in and actually try to install it, you’ll get this errror with ACCORE.DLL crashing.

After looking through a lot of different discussions boards and PDF white papers and going through a few trial runs in our lab, AutoCAD 2013 is now installed in my training rooms, pushed automatically via OU association with Group Policy. It was a little bit of a hassle to figure out the various MSI and MST files needed for successful GPO push, but alas, all is well in the universe againĀ 

Source: Autodesk Wiki Page on GPO deployment

Deploying 3ds Max Design 2013 – GPO Errors

Confirmed my licenses for 3ds max design 2013, and packaged the deployment in my DFS – no errors or failures. The next step was to deploy the software! My philosphy is always to automate as much as possible so I decided to use Group Policy to push the software out. Initially done on my lab, I then applied the GPO to one of my training rooms. EPIC FAILURE! Here’s the error message from the workstation:

Event ID 10005

Product: Autodesk 3ds Max Design 2013 64-bit — 1: 5 2: adlmPITSetProductInformation failed. 3:26

I searched for the solution, including renaming the .pit file from the Program Data directory but it didn’t work! I’ve been working on finding a solution for this so my GPO will push but nothing seems to work! Sounds like I’ll have to start a case with Autodesk! šŸ˜¦